Setting The Stops On The Front Driving Axle - Zetor PROXIMA POWER Z90 2012 Operator's Manual

SETTING THE STOPS ON THE FRONT
DRIVING AXLE
Set the stops after every change of the
wheel track of the front driving axle in
accordance with the provided tables after
loosening the nut (2) and releasing or
tightening the screw (1) to value "A". Af-
ter setting the screw (1) tighten the nut
(2) with the torque of 100 - 150 Nm.
WHEEL TRACK CHANGE
Tire
Treads
1525
1610
1620
1680
1690
1760
1770
1825
1835
1910
1920
E502
In the case of tractors equipped with the braked front axle after a change of
the front wheel track to the value of 1910 or 1920 mm it is necessary after
setting the stop screws to the value of 27 mm to check the distance between
the threaded end of the wheel screw and the wheel hub.
This distance must be at least 4 mm!
131
11,2-24 12,4-24
A (mm) A (mm)
60 61
46 55
47
39
32
27
13,6R24
A (mm)
59
50
43
34
27