Table of Contents
Advertisement
MEDIA menus
Ki Pro Quad v5.2r3
"WARNING Please Reboot" appears if media was removed without the use of the slot
button and the Ki Pro cannot continue operating and must be rebooted.
"WARNING Backup and Reformat" may appear if the media has issues being mounted by
the Ki Pro Quad. As the prompt indicates, it is best to back up the media by copying it to
another hard drive or disk array and then reformat the media. Some signs that the media
is in a read-only state: even though clips have been recorded to the media, "N/A" appears
in the clip area of the UI, "Loading" appears in the clip area of the UI but does not
eventually load a clip, or hitting the record button with all settings correctly configured
for the Ki Pro Quad does not result in a recording.
"WARNING Rollover Media Full" appears if media for a rollover is not empty and contains
existing recordings; the rollover feature requires empty media to operate.
"WARNING Rollover Media Unformatted" appears if media for a rollover is not formatted
or recognized.
"WARNING No Rollover" may appear if rollover is enabled, but no rollover media is
inserted or media that is not empty is present.
"WARNING Name in Use" appears if the clip name specified in the naming parameters
already exists on the media; this happens when take 999 is reached and no more take
numbers are available. Ki Pro Quad will refuse to overwrite the clip; you will have to
delete the clip or select a new name.
"WARNING No Clip Name" appears if you attempt to record in gang mode using a non-
existent custom clip name.
"WARNING Genlock Missing" appears if you choose "Input" or "Ref In" for 6.1 Genlock and
you attempt to play a clip and no genlock is detected on the selected input.
"WARNING 2 Channel Format" appears if the number of channels selected in 2.3 Audio
Channels is eight, but the selected audio input only supports two channels. Only SDI
supports eight channels.
"WARNING Non VFR Format" appears if 1.1 Record type is set to VFR (variable frame rate),
but the input video is not a valid VFR type. This can happen because the video format on
the selected video input doesn't support or isn't carrying VFR ancillary data, or the video
signal generator is enabled in 41.2 VIDEO SG.
"WARNING Turn Off Camera Data" appears if a camera selection has been made in the
13.1 Camera Data menu parameter, but a recording is attempted via the physical record
button on the front panel or via the record button in the web UI. To perform manually
initiated recordings, enter 13.1 Camera Data and select "None. "
"WARNING LUT Error" appears if a LUT file type that is not supported or a LUT file type
that is supported but is not formatted correctly is loaded using the web UI.
"WARNING Invalid Selection" may appear if unsupported menu selections are made for
video input, record type, encode type, etc.
As the name implies, these menu parameters display choices related to media storage
and the type of encoding to be used. There are also menus for naming reels, clips and
takes.
34
www.aja.com
Advertisement
Table of Contents
