Table of Contents
Advertisement
41.3 AUDIO SG
50.1 IP CONFIG
50.2 IP ADDRESS
Ki Pro Quad v5.2r3
the 1.6 SDI Out menu parameter should be set up for an RGB output if RGB is desired. Note
that it is also possible to configure the SDI Out for YCbCr when the Video SG Frmt is configured
for RGB, but a color space conversion will be applied to the video output.
This parameter determines the audio signal output from Ki Pro Quad's internal test signal
generator. These are the options:
OFF (default)
Silence
1 kHz
This parameter determines the type of TCP/IP network configuration used by Ki Pro
Quad. These are the options:
STATIC ADDR
DEFAULT ADDR
DHCP (default)
NOTE:
With parameters 50.1, 50.2 and 50.3, there is no timeout when editing—changes made while
in these menus will be saved and activated when the menu is exited.
This parameter determines the static IP address used by Ki Pro Quad for TCP/IP
networking.
variable
NOTE:
For parameters 50.2, 50.3, and 50.4, you will be setting IP addresses that consist of "octets"
separated by a period (i.e., 10.0.181.0). When editing these, the Select button selects the octet
and then the Adjust buttons select the desired number. Pressing Select Up again advances to
the next octet. At the final octet, the address will flash—pressing Select Up at that point
confirms the setting. When these parameters are edited, you can abort the editing process by
backing out (press the Select down arrow button repeatedly until the edit passes the first
octet). You'll notice that after completing the edit on the last octet, the display will blink—this
is an indication that the edited IP address is about to be saved. You can save the edited IP
address (press the Select arrow up to save) or choose not to save by pressing the Select arrow
down button.
Turn audio test signal output OFF.
Output an audio test signal containing silence only.
Output a standard 1 kHz test signal tone.
Assign a static IP address manually (parameters 50.2,
50.3, and 50.4 will have to be entered to accomplish
this).
Use the factory default static IP address: 10.65.74.65
Select automatic IP address assignment from DHCP
server on LAN.
NOTE: if Ki Pro Quad cannot find a DHCP server to
communicate with, it will select the default factory IP
address of 192.168.0.2.
Using the adjust buttons, enter an IP address compatible with
your LAN (if you have one). If direct connecting to a
computer, enter a legal IP address that you'll also enter in
the computer's web browser. This is only needed for Static
IP configurations.
NOTE: If 50.1 is set to DHCP and there is a DHCP failure, then
the default IP address is: 192.168.0.2
NOTE: If 50.1 is set to Default Addr, the default static IP address
is: 10.65.74.65
52
www.aja.com
Advertisement
Table of Contents
