Table of Contents
Advertisement
Clip Append (17.4):
This parameter is used with parameter 17.5 ALPHA APPEND to append a text value after
the CLIP NUMBER or have no text appended.
Alpha Append (17.5):
This parameter is used with parameter 17.4 CLIP APPEND to append a text value after the
CLIP NUMBER.
Take (17.8):
This parameter determines the TAKE number, from 1 to 999, that follows the CLIP NAME
and CLIP NUMBER, and ALPHA APPEND (if selected). To enter a specific value, click on the
number to highlight it, type in a value, and press Enter to confirm the new value. You may
also click and drag on the slider to make adjustments. To increment by single values
using the slider, click the slider to highlight it, and then press the "back" arrow or
"forward" arrow on your keyboard.
Custom Clip (19.1):
This parameter enables or disables whether a custom clip name can be used. Refer to
"Custom Clip Naming" in Chapter 4 for greater detail.
Use Custom Clip Name (19.2):
This parameter allows you to enter a custom clip name. Once entered, you'll have to click
the Apply button for it to take effect.
Use Custom Clip Take (19.3):
Enables or disables whether a custom clip take name will be used. If enabled, takes
increment sequentially from the first value selected.
NOTE:
The selection of Use Custom Clip Take is only available via the REST interface, not via the front
panel UI or web UI, and it does not survive reboots.
Caution!
If a custom clip name is not changed and the Use Custom Clip Take parameter is not
enabled, an existing clip can be overwritten on the disk. Example: the first recording
made is called "Flying" and the Custom Clip Take parameter is not enabled;
additionally, the user does not enter a new value for the custom clip name and leaves
"Flying" entered. As a result, the first recording will be overwritten by the second
recording. AJA does not typically recommend disabling the use of the custom clip
take, but in some situations, overwriting an existing file may be desirable. Again, this
menu parameter does not appear during regular operation via the front panel or the
web UI.
Custom Take (19.4):
This parameter allows you to define a custom take number. Once entered, you'll have to
click the Apply button for it to take effect. To enter a specific value, click on the number to
highlight it, type in a value, and press Enter to confirm the new value. You may also click
and drag on the slider to make adjustments. To increment by single values using the
slider, click the slider to highlight it, and then press the "back" arrow or "forward" arrow
on your keyboard.
Gang Clip Name (22.1):
This parameter is used when performing gang recording via multiple Ki Pro Quads (refer
to Controlling Multiple Ki Pro Quads later in this Chapter). If you want to name clips the
same way across all the recordings of all Ki Pro Quad ganged units, then use the Master
Name pull down selection. If you want to name clips independently on Ki Pro Quad units,
then select Slave Name from the pull down. Selecting Slave Name means that the
recording will take it's name from the individual Ki Pro Quad's parameters and not accept
the value pushed to the Slave by the Master Ki Pro Quad. Refer to "Custom Clip Naming"
in Chapter 4 for greater detail.
Ki Pro Quad v5.2r3
65
www.aja.com
Advertisement
Table of Contents
