Table of Contents
Advertisement
Deleting Clips
STATUS menus
Record Mode
Alarm Status
Ki Pro Quad v5.2r3
To delete a previously recorded clip:
1. In TRANSPORT mode, use the SELECT up and down arrow buttons to browse through
the clips on the current media. When a clip is on another media you will press SLOT
repeatedly until it's selected.
2. When you find a clip you want to delete, press the DELETE CLIP button.
3. Ki Pro Quad asks, "Are you sure. " Press the ADJUST up arrow button to confirm
deletion. Pressing the down arrow, or any other button, will abort the deletion.
The STATUS menus display I/O status and Alarm information. The STATUS menu can be
accessed almost anytime and will not change any active transport modes. Like the
CONFIG and MEDIA menus, STATUS display screens can be viewed by pushing the
SELECT up or down buttons. Pressing STATUS will exit the screens and return to
TRANSPORT mode, where an action could still be occurring (like playback or even
recording).
As mentioned earlier in this chapter:
Line 1: Displays the current clip on the left side and the current slot and percentage of the
media capacity remaining on the right side.
Line 2: Displays the current reel number on the left side and the timecode for the clip
being recorded or played on the right side.
The Alarm menu displays warnings and alarms. Some alarms will automatically be shown
on the display. Others will only be seen by checking the STATUS displays (press Select up/
down to cycle through them). If everything is OK, then a "SYSTEM NORMAL" message will
be seen when you cycle through the STATUS displays.
Examples of ALARM displays are shown below. WARNING appears on the first line and
the prompted action item on the second line.
Figure 10. Warning Examples
WARNINGS
No Media
WARNINGS
Media Removed
WARNINGS
Media Low
WARNINGS
No Video Input
32
www.aja.com
Advertisement
Table of Contents
