AJA Ki Pro Quad Installation & Operation Manual page 47

4k / ultrahd / 2k / hd solid state file based recorder
Hide thumbs Also See for Ki Pro Quad:
Table of Contents

Advertisement

8.2 TC TYPE
8.3 ARM RECORDING
9.0 INTERVAL RECORD
9.1 INTERVAL FRAMES
Ki Pro Quad v5.2r3
This parameter selects drop frame or non-drop frame timecode. These are the options:
NDF (default)
DF
NOTE:
If the menu parameter 8.0 TC In is set to SDI RP188 or LTC, the TC Type selection does not
apply. TC Type only applies to the TC Value or the Time of Day value generated by the Ki Pro
Quad.
This parameter selects how recording may be initiated—either by pressing the physical
record button or by incrementing ststop timecode values. These are the options:
REC KEY (default)
TC/REC KEY
If arm recording on timecode, parameters 8.0, 8.1. and 8.2 must be set to a qualified
source and type of timecode. You should use timecode that starts and stops, like that
produced by record run timecode; freerun timecode is not viable for this feature since it
does not produce start and stop values.
The Ki Pro Quad can be used to create timelapse recordings via the 9.0 Interval Record,
9.1 Interval Frames and 9.2 Interval Time selections. These are the options:
OFF (default)
ON
Example of timelapse recording selections:
The incoming video signal is 1080i 29.97 fps, the record button is depressed, and the
recording is then stopped 90 seconds later with the following settings:
9.0 Interval Record > On
9.1 Interval Frames > 1
9.2 Interval Time > Second
The resulting recording would be 90 frames in duration, would have a frame rate of 29.97
fps, and would appear to be "undercranked" or "sped up" when compared to a normally
created recording.
NOTE:
Selecting an interval frame number that exceeds the incoming video frames per second will
result in normal video. "Overcranking" or "slow mo" is not supported by the interval recording
feature.
Determines how many frames from the incoming video will be used for the recording.
These are the options:
Incrementing Value
Selects Non-drop Frame timecode
Selects Drop Frame timecode
Start when Record button is pressed
Start on Time Code or Record button
Normal recordings are produced.
Timelapse recordings are produced.
Sets number of frames to use for the recording.
47
www.aja.com

Advertisement

Table of Contents
loading

Table of Contents