Mounting Option Boards - Omron G9SP-N20S Operation Manuals

Installation
4-1-5

Mounting Option Boards

Mounting and Removal
Mounting
1,2,3...
Removal
Precautions When Connecting an Option Board
Applicable Models
Maximum Number of Boards
62
This section describes how to mount an Option Board.
1. Turn OFF the power supply to the G9SP-series Controller.
2. Remove the cover to the Option Board slot. If you squeeze the top and bot-
tom lock levers on the cover together to release the lock, you can remove
the cover.
3. Make sure the Board is in the correct orientation and firmly press it into the
slot until it clicks into place.
Always turn OFF the power supply before removing an Option Board. If you
squeeze the top and bottom lock levers on the Option Board together to
release the lock, you can remove the Option Board.
Precautions for Correct Use
Always turn OFF the power supply to the G9SP-series Controller before
mounting or removing Option Boards.
The following restrictions apply to the Option Boards that can be mounted to
the G9SP-series Controller.
Refer to 1-1-2 Basic System and Configuration Devices for information on the
Expansion I/O Units that can be connected.
Only one Option Board can be mounted.
Section 4-1