Displaying And Printing Reports - Omron G9SP-N20S Operation Manuals

Creating Configuration Data
6-2-5

Displaying and Printing Reports

What Is a Report?
Note
Configuration Data Application Example
■
Using a CP1W-CIF41 Ethernet Communications Board
TCP/IP settings, such as the IP address, must be made in the system settings
if an Ethernet Communications Option Board is used. Refer to 7-3 Ethernet
Communications for details on settings.
A report (i.e., a configuration report) on the configuration data that has been
set is displayed on the computer screen to check setting details.
The G9SP Configurator creates two types of reports. The characteristics of
each type are given in the following table.
Item
Purpose
Displayed contents
Printing
Saving to file
Display timing
(1) Refer to 8-2-3 Verifying the Configuration Data for information on verifica-
tion.
(2) The configuration report can be saved to a file by using commercially
available PDF creation software.
■ Documentation Showing the Configuration Data Contents
Forming the details of settings made with the G9SP Configurator into a report
enables using the data for other applications.
■ Notification to Hardware Designers
Hardware designers require information on the I/O terminal allocations, cycle
time, and ON/OFF delay values to create wiring diagrams and to calculate
safety response performance. The report includes that information and can be
used as documentation for notification of details.
Configuration report
• Documentation showing the
configuration data contents.
• Notification to hardware
designers.
Configuration data
Supported
Not supported
When Print Preview is
selected from the File Menu.
Section 6-2
Verification report
Checking if the configuration
data has been correctly down-
loaded to the G9SP-series
Controller.
Verification results and config-
uration data.
Supported
Supported
After executing Communica-
tion - Verify.
87