Restoring Data To G9Sp-Series Controller - Omron G9SP-N20S Operation Manuals

Restoring Data to G9SP-series Controller

11-3 Restoring Data to G9SP-series Controller

Conditions
What Is Restore Prohibition?
164
This section describes the conditions and procedures for restoring data.
The following conditions must be satisfied to restore data.
• Backup of Correct Data on a Memory Cassette
The configuration data must be backed up on a Memory Cassette in
advance.
• Device Password Match
If a device password is set, the device password set for the G9SP-se-
ries Controller must match the device password that is backed up on
the Memory Cassette. A device password is not set in the default set-
tings.
• Prohibit Restore Setting Disabled
The restore prohibition setting made for the G9SP-series Controller
must be disabled. Restore prohibition is enabled in the default settings.
• Model Information (Model) Match
The model information in the configuration data stored on the Memory
Cassette must match the model information in the G9SP-series Con-
troller.
This setting enables prohibiting restoring data using a Memory Cassette to
prevent incorrect or improper restoration for equipment at the work site. If the
prohibit restore setting is enabled, a computer will be required to update the
configuration data. Be sure to set this setting correctly.
Data cannot be restored to
a G9SP-series Controller
for which restoring data is
prohibited.
Data can still be downloaded to
a G9SP-series Controller for
which restoring data is prohibited.
The prohibit restore setting is made in the system settings from the G9SP
Configurator. For the setting procedure, refer to SECTION 6 Creating Configu-
ration Data.
The computer or Memory Cassette is
used in advance to prohibit restoring data.
Memory Cassette
MEMORY
MEMORY
Prohibiting Data
Restoration
Section 11-3
G9SP Configurator