Thermo Scientific AI 1310 User Manual page 96

4
AI 1310/AS 1310 Control
Guidelines for Programming with Different Injectors
Table 11. Summary of Injection Parameters and Conditions
Mode Technique
Split Hot Needle
Split Cold Needle
Splitless Hot Needle
Splitless Cold Needle
1
SSL Nano-Volumes Cold Needle
1
Only with 0.5μL syringe.
72 AI 1310/AS 1310 Sampling System - User Guide
Column
Liner Type
Insertion
40 mm Tubular Liner
(3 or 5 mm ID)
40 mm Tubular Liner
(3 or 5 mm ID)
64 mm Tapered Liner
(3 or 5 mm ID)
50 mm Tapered Liner
(3 or 5 mm ID)
40 mm Double Tapered Liner No
Packing of
AI 1310/AS 1310 Injection Parameters
Liner
Not required Injection depth = Standard
Pre Inject Delay Time = 3-5 s
Post Inject Delay Time = 0 s
(Chromeleon CDS)
Pre Injection Dwell Time = 3-5 s
Post Injection Dwell Time = 0
(Xcalibur, ChromCard, ChomQuest CDS)
Packing material Injection depth = Minimum
at half height
Pre and Post Inject Delay Time = 0 s
(Chromeleon CDS)
Pre and Post Injection Dwell Time are
automatically inhibited
(Xcalibur, ChromCard, ChomQuest CDS)
Not Required Injection depth = Standard
Pre Inject Delay Time = 3-5 s
Post Inject Delay Time = 0 s
(Chromeleon CDS)
Pre Injection Dwell Time = 3-5 s
Post Injection Dweel Time = 0
(Xcalibur, ChromCard, ChomQuest CDS)
Packing material Injection depth = Minimum
at bottom
Pre and Post Inject Delay Time = 0 s
(Chromeleon CDS)
Pre and Post Injection Dwell Time are
automatically inhibited
(Xcalibur, ChromCard, ChomQuest CDS)
Injection depth = Minimum
Pre and Post Inject Delay Time = 0 s
(Chromeleon CDS)
Pre and Post Injection Dwell Time are
automatically inhibited
(Xcalibur, ChromCard, ChomQuest CDS)
Thermo Scientific