Thermo Scientific AI 1310 User Manual page 84

4
AI 1310/AS 1310 Control
Control Through the Chromatography Data System
60 AI 1310/AS 1310 Sampling System - User Guide
Post Inject Delay Time — Determines for how long the syringe remains in the injector after
the injection. The range is 0-63 seconds.
Note You can also use the Post Inject Delay Time and Pre Inject Delay Time Properties to
specify the needle depth during the injection. The following settings are available.
• Standard: Post Inject Delay Time or Pre Inject Delay Time > 0
• Minimum: Post Inject Delay Time and Pre Inject Delay Time = 0
Pre Wash — Specifies the number of pre-injection cleaning cycles. The range is 0-15.
Post Wash — Specifies the number of post-injection cleaning cycles. The range is 0-15.
Pre Wash Vial — Specifies which vials are used for washing the syringe before the injection
with the solvents. The options are: A, B, C, D, A+B and C+D.
Post Wash Vial — Specifies which vials are used for washing the syringe after the injection
with the solvents. The options are: A, B, C, D, A+B and C+D.
Position — Specifies the vial position in the tray.
Sample Depth — Specifies how deep the needle descends into the vial when drawing the
sample for injection. The options are: Bottom or Half.
Sample Wash — Determines the number of cleaning cycles with sample before injection. The
range is 0-15.
State — Indicates the status of the autosampler (ready-only).
• On = the injection has been performed.
• Off = the injection has not yet been performed.
Syringe Volume — Specifies the total capacity of the syringe: 0.5 μL, 5 μL, or 10 μL. See also
the Configuration page.
Tray Type — Specifies the tray type: 8, 105, or 155 vials. See also the Configuration page.
Volume — Specifies the injection volume.
Commands
The following commands are available:
Connect — Connects the autosampler to the data system.
Disconnect — Disconnects the autosampler from the data system.
Clean — (obsolete AI/AS 1310 drivers only) Cleans the syringe in combination with the
washing parameters.
Thermo Scientific