Table of Contents
Advertisement
3. Operation Procedures
Tapping the START button starts an operation in SCAN mode according to the
measurement settings. The START button will be replaced with the STOP button. After
the Wait Time elapses, a measurement will be started.
【Caution】
If two (2) or more measurements are conducted within one (1) minute and
the measurement results are stored in the internal memory, only the newest
result will be saved.
START button
Charging Level of
the Corona Current
*When the charging level of the
corona current is not at maximum, a
measurement
even if the START button is tapped.
During
a
measurement,
(Particles/cc ） will be displayed in a
graph. To stop a measurement, tap the
STOP button.
Once a measurement
stops, data will be stored in the internal
memory and the screen will be changed
from
the
SCAN
REDUCTION screen.
cannot
be
started
raw
data
screen
to
the
15
Advertisement
Table of Contents
