Table of Contents
Advertisement
3. Operation Procedures
(3) Status Display
(in detail)
Ready
Measure
Wait
COMERR
ALCOHOL
FLOWERR
TILTERR
MEMERR
(4) Operating Icon
display
START
STOP
SETTING
MENU
After the warm-up process is completed, screens can be switched by tapping the tabs [SCAN],
[SINGLE] and [REDUCTION].
[SCAN]
[SCAN]: Displays particle size distribution (X axis: particle size, Y axis: number concentration)
[SINGLE]：Displays number concentration of the selected particle size
[REDUCTION]：Displays particle size distribution resulting from a compensation calculation.
(X axis: particle size, Y axis: number concentration)
Displays the conditions of the main unit and power source; corona current
and the current time.
Indicates that the instrument is powered by an AC adapter or a battery.
When the instrument is battery-operated, the remaining battery level will be
also indicated.
Indicates the level of corona current charged to both electrodes on a scale of
1 to 5.
Indicates the instrument is ready to start a measurement.
Indicates a measurement is in process.
Indicates the instrument is preparing for a measurement (e.g. saving data).
Indicates an error on the internal mainboard.
Indicate that the alcohol is refilled too much.
Indicates the flow rate is not within the specified parameters.
Indicates the instrument is tilted.
Indicates the internal flash memory has run out of free space.
To perform the following operations:
Starts a measurement in the mode selected by the tab (SCAN or SINGLE).
After a measurement starts, this button will be replaced with the STOP
button.
Stops an ongoing measurement.
button will be replaced by the START button.
Displays the Measure Settings window for each mode to configure the
measurement conditions.
Displays status and stored data; configures the system settings, and etc.
[SINGLE]
After stopping the measurement, this
[REDUCTION]
11
Advertisement
Table of Contents
