Table of Contents
Advertisement
3. Operation Procedures
Wait Time
Meas Time
No. of Scans
Y Scale
Graph Y Max
Graph Y Min
Data Folder
Para Folder
Sheath Flow
[Measurement Time]
If the settings are as follows, the whole measurement time can be calculated as shown
below:
(example) Wait Time: 20 seconds
Meas Time: 10 seconds/ch
No. of Scans: 10 scans
Sheath Flow: Wide Range（14ch）
Loop Wait: 20 seconds
*Loop Wait: wait time set for each scan (unchangeable)
Measurement time
= 15 seconds＋（20 seconds＋10 seconds/chｘ14ch）ｘ10＝1,570 seconds
Sets a wait time before starting a measurement. Settable range is
from 0 to 600 seconds.
Sets a measurement time per channel (ch). Settable range is
from 2 to 600 seconds/ch.
Sets the number of scans. Settable range is from 1 to 1,000 scans.
Select Auto to change the Y axis of the graph automatically
according to the measurement results.
Select Manual to fix the Y axis of the graph regardless of the
measurement results. Tap Auto or Manual to select either of
them.
Sets the maximum value of the Y axis of the graph. This parameter
is valid when the Y Scale is set to Manual. The settable range is
from 1 to 30,000,000 pcs/cc.
Sets the minimum value of the Y axis of the graph. This parameter
is valid when the Y Scale is set to Manual. The settable range is
from 0 to 29,999,999 pcs/cc.
Assign a folder to store the measurement results. When a USB
flash drive is installed, this Data Folder will be created on the USB
flash drive. The factory default folder is SCAN.
Assign a folder to record the parameters. When a USB flash drive
is installed, this Para Folder will be created on the USB flash drive.
The factory default folder is PAMS.
In the High Resolution mode, a range from 10nm to 433.7nm is
divided into 27 classifications to perform measurements with a high
accuracy.
In the Wide Range mode, a range from 14.5nm to
862.3nm is divided into 14 classifications to perform quick
Select the High Resolution or Wide Range by
measurements.
tapping either of them.
14
Advertisement
Table of Contents
