Configuration Parameters
Table C-1:
Parameter
100% auxiliary
0% auxiliary
C.2.2
Units
The units for length, volume, temperature, and level rates are selectable. All configuration
parameters and transmitter variables will be expressed in these units. For information on
available units of measure, see
C.2.3
Analog output
The output source (primary variable), range values, and alarm mode are specified for the
analog output.
Primary variable
Select the desired transmitter variable to use for the analog output.
Upper/lower range value
Enter the range values that correspond to the analog output values 4 and 20 mA. The
transmitter will drive the output to saturation mode if a measured value goes outside the
4-20 mA range values.
Note
Measurements may not be possible in the blind zone, and measurements close to the blind zone will
have reduced accuracy (see
these zones.
224
Percent of range auxiliary
Output
Figure
A-1). Therefore, the 20 mA point should be configured outside
Description
Value corresponding to 100% range of variable
selected for percent of range auxiliary.
Value corresponding to 0% range of variable se-
lected for percent of range auxiliary.
units.
Reference Manual