Table of Contents
Advertisement
®
ABB i-bus
KNX
Device technology
2
Device technology
2.1
FCL/S x.6.1.1 Blower Actuator x-fold, 6 A, MDRC
FCL/S 2.6.1.1
2.1.1
Technical data
Power supply
Rated output value
Output switching current
Output service life
1)
The maximum inrush current peak may not be exceeded.
The FCL/S x.6.1.1 Blower Actuator is a
modular installation device (MDRC) in
ProM design. It is intended for installation
in the distribution board on 35 mm mount-
ing rails. The assignment of the physical
address as well as the parameterization
is carried out using ETS and the current
application.
KNX bus voltage
Current consumption, bus
Power consumption
FCL/S Type
Number
U
rated voltage
n
I
rated current (per output)
n
Leakage loss per device at max. load
operation (cos = 0.45)
2)
AC3
To EN 60 947-4-1
operation (cos = 0.8)
2)
AC1
To EN 60 947-4-1
Fluorescent lighting load to EN 60 669-1
Minimum switching capacity
Mechanical service life
Electronic endurance
to IEC 60 947-4-1
(240 V/cos = 0.8)
2)
AC1
(240 V/cos = 0.45)
2)
AC3
(240 V/cos = 0.45)
2)
AC5a
The device is powered via the
®
ABB i-bus
KNX and requires no addi-
tional auxiliary voltage supply.
The device is ready for operation after
connecting the bus voltage.
21...32 V DC
< 12 mA
Maximum 250 mW
1.6.1.1
2.6.1.1
4
8
250/440 V AC (50/60 Hz)
6 A
6 A
1.5 W
2.0 W
6 A/230 V AC
6 A/230 V AC
6 A/250 V AC (35 F)
1)
20 mA/5 V AC
10 mA/12 V AC
7 mA/24 V AC
7
> 10
5
> 10
4
> 1.5 x 10
4
> 1.5 x 10
FCL/S x.6.1.1 | 2CDC508116D0203 7
Advertisement
Table of Contents
