Table of Contents
Advertisement
®
ABB i-bus
KNX
Planning and application
4.4.3
ETS reset
What is an ETS reset?
Generally an ETS reset is defined as a reset of the device via ETS. It is initiated in ETS under the menu
item Commissioning with the function Reset device. This stops and restarts the application.
4.4.4
Download
During a download, the output behaves just as it would on bus voltage failure.
Note
After a download with a change, the parameter responds as if there has been an ETS reset.
If the application is downloaded again (full download) after a full discharge, the response is the same as
after an ETS reset.
After the application is removed or after an interrupted download, manual operation no longer functions.
FCL/S x.6.1.1 | 2CDC508116D0203 93
Advertisement
Table of Contents
