Start-Up; Overview - ABB i-bus KNX FCL/S 1.6.1.1 Product Manual

®
ABB i-bus KNX

Start-up

3 Start-up
The blower actuator is parameterized with the Switch Blower 1f 6A/1.0 (FCL/S 1.6.1.1) or Switch Blow-
er 2f 6A/1.0 (FCL/S 2.6.1.1) application, and ETS Engineering Tool Software. The application provides the
device with a comprehensive and flexible range of functions. The standard settings allow simple commis-
sioning. The functions can be extended if required.
3.1

Overview

The following functions are available:
Fan
stagePower outlets (sockets)
Illumination
Caution
Improper switching will destroy the fan motors.
Follow the technical data for the fan, e.g. speed or switching function.
For further information see:
The blower actuator features relays in each output which are mechanically independent of the other out-
puts. Switching noises cannot be avoided due to the mechanical nature of the design.
The device is installed primarily in the distribution board together with the circuit-breakers and RCCBs.
Usually, the blower actuator is used in conjunction with a room thermostat for an individual room tempera-
ture control system. The room thermostat sends a control value which the blower actuator uses to control
the fan speeds.
A three-speed fan is controlled alternately with a two-way connection or with speed
switching.
For power supply to individual power outlet circuits and other loads.
For power supply to individual lighting circuits and other loads.
Parameter window A: Fan (Multi-level), p.21.
FCL/S x.6.1.1 | 2CDC508116D0203 15