®
ABB i-bus
KNX
Start-up
3.2.2.3.1
Parameter window - Status messages (One-level)
This is the parameter window where status messages are defined.
This parameter window is always visible for output A. For outputs C, D and E it is visible if the Outputs C,
D, E parameter in
Enable communication object
"Status Byte mode" 1 byte
Options:
This status byte indicates the states Control value selection, Automatic, Forced operation and the four limi-
tations via a 1 bit coding.
For further information see:
Yes: The communication object Status Byte mode is enabled and the following parameter appears:
Parameter window Enable outputs A...F
No
Yes
Fan status byte,
Send object values
Options:
No, update only
Only after changing
After request
After a change or request
No, update only: The status is updated but not sent.
Only after changing: The status is sent after a change.
After request: The status is sent after a request.
After a change or request: The status is sent after a change or a request.
on p.20 is set to Enable as fans.
forced/operation, p.98
FCL/S x.6.1.1 | 2CDC508116D0203 47