Table of Contents
Advertisement
ABB i-bus
EIB / KNX
®
2
Device technology
AA/S 4.1
Fig. 1: AA/S 4.1
2.1
Technical Data
Power supply
Outputs
Output current
Operating and display elements
Connections
Enclosure
Ambient temperature range
Humidity
Design
Housing, colour
Installation
Dimensions
Mounting depth / width
Weight
Mounting position
Approvals
CE mark
Device Technology
Analogue Actuator AA/S 4.1
The Analogue Actuator converts measured data received via the EIB / KNX
to analogue output signals. The device features four outputs. The analogue
outputs can be used as current or voltage outputs with adjustable out-
put signals. The number of analogue outputs can be increased to 8 using
the Analogue Actuator Module AAM/S. The Analogue Actuator is a DIN
rail device for installation in the distribution board. The connection to the
EIB / KNX is established using a bus connection terminal. The device needs
an external 24 V AC power supply.
Operating voltage
Bus voltage
Current consumption device / EIB / KNX
Power consumption
4 analogue outputs A1...A4
Signal type
Output signal load
Voltage signal
Current signal
Device status display
Output signal A1...A4 display
Programming button and LED (red)
EIB / KNX
Analogue outputs A1...A4
24 V AC power supply
System connector, 6-pole
IP 20, EN 60 529
Operation
Storage
Transport
Ambient/Storage/Transport
Modular installation device
Plastic housing, grey
On 35 mm mounting rail
90 x 72 x 69.5 mm (H x W x D)
70 mm / 4 modules at 18 mm
approx. 180 g
as required
EIB / KNX to EN 50 090-1, -2
in accordance with the EMC guideline and low
voltage guideline
24 V AC ± 10 %
21 ... 30 V DC via EIB / KNX
Max. 310 mA / < 10 mA
typ. 150 mW
Extendable with Analogue Actuator Module
AAM/S to 8 outputs
0 ... 1 V DC
0 ... 20 mA
0 ... 10 V DC
4 ... 20 mA
depending on parameterisation
Voltage signal:
1 kΩ
500 Ω
Current signal:
Max. 10 mA per channel
Max. 20 mA per channel
Status LED (3-colour: red, orange, green)
Status LED (yellow)
For assignment of the physical address
Bus connection terminal (black/red)
2 screw terminals per output/terminal
Conductor cross-section:
single-core: 0.50 – 4.0 mm²
stranded:
0.34 – 4.0 mm²
stranded:
0.14 – 2.5 mm²
Connection for max. 1 analogue actuator
module
– 5 °C ... + 45 °C
– 25 °C ... + 70 °C
– 25 °C ... + 70 °C
Max. 93 % rel. humidity, no condensation
to DIN EN 50 022
3
Advertisement
Table of Contents
