Parameter Window Enable Outputs A - ABB i-bus KNX FCL/S 1.6.1.1 Product Manual

®
ABB i-bus KNX
Start-up
3.2.2 Parameter window Enable outputs A...F
Note
All parameter window descriptions and control options refer to the FCL/S 2.6.1.1 2-fold Blower Actuator.
The application for the FCL/S 1.6.1.1 1-fold Blower Actuator has no Enable outputs A...F parameter
window, i.e. output A is always a fan output and the additional switch output B is always activated.
In this parameter window you can enable outputs A...F.
Output A
Options:
Output A is always enabled as a fan.
Outputs B and F
Options:

Block: output B or F is blocked/hidden. No communication objects are visible.

Enabled: The parameter window B or F: Output appears. Dependent communication objects become
visible.
Outputs C, D, E
Options:
Outputs C, D and E can be programmed as fans or switch actuators.

Enable as fans: The parameter window C, D, E: Fan appears.

Enable as switch actuators: Outputs C, D and E appear as individual parameters and can be enabled
individually.
The descriptions of the parameter setting options and the adjustable communication objects for outputs C,
D, E are the same as for output A (if enabled as a fan) or B (if enabled as switch actuators), see
ter window A:
20 2CDC508116D0203 | FCL/S x.6.1.1
Enable as fans
Enable
Block
Enable as fans
Enable as switch actuators
Fan, p.21 or Parameter window B: Output, p.55.
Parame-