Set Supervisor/User Password - AXIOMTEK SBC84820 Series User Manual

SBC84820 Pentium

4.15 Set Supervisor/User Password

You can set either supervisor or user password, or both of then.
The differences between are:
Supervisor password: can enter and change the
1.
options of the setup menus.
User password: just can enter but do not have the
2.
right to change the options of the setup menus.
When you select this function, the following message will
appear at the center of the screen to assist you in creating a
password.
Type the password with eight characters at most, and press
<Enter>. The password typed will now clear any previously
entered password from CMOS memory. You will be asked to
confirm the password. Type the password again and press
<Enter>. You may also press <Esc> to abort the selection and
not enter a password.
To disable password, just press <Enter> when you are
prompted to enter password. A message will confirm the
password being disabled. Once the password is disabled, the
system will boot and you can enter Setup freely.
When a password is enabled, you have to type it every time
Award BIOS Utility
®
M All-in-One Capa Board User's Manual
ENTER PASSWORD:
PASSWORD DISABLED.
63