The System Cannot Be Started Up - Fujitsu PRIMERGY 300 Operating Manual

The system cannot be started up

The system cannot be started up
The system reports one of the following error messages:
Invalid configuration information
Invalid EISA configuration storage
If you receive one of these messages after system startup, the configuration
information for your EISA system has been deleted. In this case you must restore
the EISA configuration. There are two possibilities to procede: You can either
repeat the configuration procedure in its entirety (see user manual for EISA
configuration), or better still, you can reload the configuration data (SCI file) that
you saved on floppy disk back onto your system. This possibility is described
below.
EISA configuration restoring (Load SCI file)
Insert the configuration utility disk in floppy disk drive. The disk must not be
Ê
write protected.
Restart the server.
Ê
Having run through its power-on self-test, the system starts the EISA configuration
utility from the floppy disk.
Ê Confirm the logo screen by pressing the Enter key.
The welcome screen contains a CMOS error message. Attempt to correct the error
by running through the following two configuration procedures which are described
in detail below:
•
Start by running through the EISA configuration procedure and selecting the
menu items Add or remove boards and View or edit details in order to write valid
setup information to the CMOS RAM.
•
Run through the EISA configuration procedure a second time and load an SCI
file from the EISA configuration utility floppy disk.
If these measures do not help, consult your supplier or our service
i
technicians.
A26361-K423-Z202-3-7619
Troubleshooting and tips
43