The Floppy Disk Cannot Be Read Or Written; Time And/Or Date Is Not Correct - Fujitsu PRIMERGY 300 Operating Manual

Troubleshooting and tips
Mouse not connected
Ê Switch the server off.
Check whether the mouse cable is properly connected to the system unit.
Ê
Switch your server on.
Ê

The floppy disk cannot be read or written

Check whether the write protection of the floppy disk is activated.
Ê
Ê In the BIOS-Setup check the entry for the floppy disk drive.
Check in the BIOS Setup whether the diskette drive controller and write
Ê
permission are enabled (see the Technical Manual for the system board).
Check whether the lines of the floppy disk drive are properly connected (refer
Ê
to chapter "System

Time and/or date is not correct

Set the time and/or date. You can set the time and date in the BIOS Setup.
Ê
If the time and date are repeatedly wrong when you switch on your
i
Server, the battery is flat. Change the lithium battery as described in the
Technical Manual of the system board.
42
The floppy disk cannot be read or written
expansions").
A26361-K423-Z202-3-7619