No Mouse Pointer Displayed On The Monitor; The Floppy Disk Cannot Be Read Or Written; Time And/Or Date Are Incorrect - Fujitsu PRIMERGY H250 Manual

Server system
Hide thumbs Also See for PRIMERGY H250:
Table of Contents

Advertisement

No Mouse Pointer Displayed on the Monitor

7.6
No Mouse Pointer Displayed on the Monitor
Mouse Driver not Loaded
Ê Check whether the mouse driver is properly installed and is present when
the application programme is started. Detailed information can be found in
the documentation for the mouse, the operating system, or the application
programme.
Mouse Controller Disabled
The mouse controller on the system board must be enabled if you use the
supplied mouse.
Ê Check in the BIOS-Setup that the mouse controller is Enabled.
7.7

The Floppy Disk cannot be Read or Written

Ê Check whether the write protection of the floppy disk is activated.
Ê Check in the BIOS Setup the entry for the floppy disk drive.
Ê Check in the BIOS Setup whether the diskette drive controller and write
permissions are enabled (see the technical manual for the system board).
7.8

Time and/or Date are Incorrect

Ê Set the time and/or date in the operating system or in the BIOS-Setup.
I
If the time and date are repeatedly wrong when you switch on your
server, the battery is flat. Change the lithium battery as described in the
technical manual for the system board.
66
Problem Solutions and Tips
U41271-J-Z156-2-76

Advertisement

Table of Contents
loading

Table of Contents