The Floppy Disk Cannot Be Read Or Written; Incorrect Time And/Or Date; System Fails To Boot - Fujitsu PRIMERGY RX300 S3 Operating Manual

The Floppy Disk Cannot be Read or Written

Mouse controller disabled
The mouse controller on the system board must be enabled if you use the
supplied mouse.
Ê Check in the BIOS Setup that the mouse controller is Enabled.
7.7 The Floppy Disk Cannot be Read or Written
Ê Check whether the write protection for the floppy disk is activated.
Ê Check the entry for the floppy disk drive in the BIOS Setup.
Ê Check in the BIOS Setup whether the floppy disk drive controller and write
permission are enabled (see technical manual for system board on the
PRIMERGY ServerBooks DVD).
7.8

Incorrect Time and/or Date

Ê Set the time and/or date in the operating system or in BIOS Setup.
I
If the time and date are repeatedly wrong when you switch ON your
server, you must change the lithium battery. Contact our Service group.
7.9

System Fails to Boot

The system will not boot after installing a new hard disk drive.
Incorrect SAS configuration
Ê In the SAS configuration menu check the settings for the hard disk drives
(SAS Device Configuration) and the additional settings.
70 Operating manual
Troubleshooting and Tips
RX300 S3