Table of Contents
Advertisement
System expansions
Put the floppy disk drive and the carrier back into the housing.
Ê
Fasten the carrier with the screws removed earlier.
Ê
Ê
Plug the data line to the corresponding connector on the system board (see
Technical Manual of the system board).
Close the server (see
Ê
If the new floppy disk drive has different parameters from the old one, amend
Ê
the corresponding entry in the BIOS Setup.
68
"Assembling the
Installing and removing drives
server").
A26361-K423-Z202-3-7619
Advertisement
Table of Contents
