Icu Utility; Configuring The Disk Array Controller (Eisa) - Fujitsu PRIMERGY 300 Operating Manual

Select the item Create a backup SCI file, and press the Enter key.
Ê
The Save System Configuration Information (SCI) File Description window appears.
Enter the file name and press the Enter key.
Ê
The Save System Configuration Information (SCI) File Description window appears.
Enter a description of the contents of the file, e.g., factory configuration, and
Ê
press the Enter key.
The system reports that an SCI file was created successfully.
Press the Enter key to confirm the message.
Ê
The Maintain System Configuration Diskette menu is displayed.
Select the item Exit and press the Enter key.
Ê
The main menu appears.
Select the item Exit from this utility and press the Enter key twice.
Ê
This exits the EISA configuration program.

ICU utility

You can use the ICU utility (ISA Configuration Utility) to configure Plug&Play or
standard ISA boards. You can also use ICU to check the server system resources
(e.g. interrupts used). Using the ICU program is described in the User Guide.

Configuring the Disk Array Controller (EISA)

If your server is fitted with a Disk Array Controller (DAC) for the EISA-Bus, you
must perform the following steps:
•
perform the EISA configuration for the DAC
•
create a DOS system disk for the DAC configuration
•
Performing DAC configuration
A26361-K423-Z202-3-7619
Preparation for use and operation
23