Floppy Disk Cannot Be Read And/Or Written; Incorrect Time And/Or Date; System Will Not Boot - Fujitsu PRIMERGY RX220 Operating Manual

Floppy Disk Cannot be Read and/or Written

Mouse controller disabled
The mouse controller on the system board must be enabled if you use the
supplied mouse.
Ê Make sure in the BIOS Setup Advanced menu that the mouse controller is
Enabled.
7.7 Floppy Disk Cannot be Read and/or Written
Ê Check whether the write protection for the floppy disk is activated.
Ê Check the entry for the floppy disk drive in the BIOS Setup Main menu.
Ê Check in the BIOS Setup Advanced menu whether the floppy disk drive
controller is Enabled.
Ê Check in the BIOS Setup Security menu whether the floppy disk drive write
permission is Enabled. See
7.8

Incorrect Time and/or Date

Ê Set the time and/or date in the operating system or in the BIOS Setup Main
menu.
I
If the time and date are repeatedly wrong when you switch on your
server, you must change the lithium battery. Contact our Service group.
7.9

System Will Not Boot

The system will not boot after installing a new hard disk drive.
Incorrect SATA configuration (SATA Controller)
Ê In the SATA configuration menu, check the settings for the hard disk drives.
60
"Protecting BIOS from overwriting" on page 55
Operating Manual
Troubleshooting and Tips
RX220