Code To Isolate; Fault Analysis Mode - Bosch Solution 2000 Installation Manual

36 en | System Operations
3.
Notice!
As each zone is selected to be isolated, the corresponding zone indicator flashes. If you make
a mistake, enter the incorrect zone number and press [STAY]. This zone is no longer selected
to be isolated and the zone indicator is extinguished.
4.
Two beeps sound and the system returns to the disarmed state.
The indicators for the selected zones continue to flash until the next time the system is
disarmed.
Example:
To manually isolate zones 1, 3, and 4, press: [STAY][STAY][1][STAY][3][STAY][4][STAY]
[AWAY]
6.11.2

Code to isolate

The code to isolate method permits only those User Code holders with a priority level that
includes Code to Isolate. The standard isolating method is disabled for any User Code with
this priority level set.
1.
2.
3.
4.
Notice!
As each zone is selected to be isolated, the corresponding zone indicator flashes. If you make
a mistake, enter the incorrect
zone number and press [STAY]. This zone is no longer selected to be isolated and the zone
indicator is extinguished.
5.
Two beeps sound and the system returns to the disarmed state.
The indicators for the selected zones continue to flash until the next time the system is
disarmed.
Example
To manually isolate zones 1, 3, and 4, press: [STAY][User Code][STAY][1][STAY][3][STAY][4]
[STAY][AWAY]
6.12

Fault analysis mode

When a system fault occurs, the FAULT or MAINS indicator flashes and the codepad beeps
once per minute.
If the AC MAINS supply fails, the MAINS indicator flashes until the AC MAINS supply is
restored. Press [AWAY] once to acknowledge the fault and stop the codepad from beeping
once every minute.
2017.10 | 03 | F.01U.298.026
Repeat Step2 for each zone you want to isolate.
Press [AWAY].
Press [STAY].
Enter your code and press [STAY]. Three beeps sound and the STAY indicator flashes. If
you attempt to enter isolating mode with a User Code that is not set for Code to Isolate,
the system ignores the attempt.
Enter the number of the zone to be isolated and press [STAY]. The indicator for the zone
flashes. 24-Hour zones are automatically isolated as soon you press [STAY]. All other
Burglary zones are automatically isolated only after the system is armed.
Repeat Step3 for each zone you want to isolate.
Press [AWAY].
Installation Guide
Control Panel
Bosch Security Systems, Inc.