20
en | Accessories
4.6
RADION repeater
RADION repeater receives transmissions from RADION transmitters and re-transmits them to
improve transmitted message reliability and range for compatible transmitters and its
assigned compatible receiver.
For more information, refer to the installation and operation guides for this product.
4.7
RADION detectors
For more information regarding the sensors supported by the Solution 3000 control panel,
refer to the installation and operation manuals for the B810 wireless receiver.
See also
–
4.8
B308 Octo-output Module
The B308 Octo-output Module is a supervised device that provides 8 programmable outputs
(Form C relays) and connects to control panels through the SDI2 bus. Each output provides
dry contact switching rated for a maximum of 1.0 A at 24 VDC. The outputs are accessed
through on-board screw terminal connections. The address switches are used to set the
module's SDI2 address. Control panel programming determines each output's response to
specific events. The B308 receives serial data from the control panel and activates outputs in
response to control panel conditions and settings. Outputs can be programmed for remote
control from a control panel codepad or computer (A-Link) or smartphone application (RSC).
Set the address
Two address switches determine the address for the B308 Octo-output Module. The control
panel uses the address for communications. Use a slotted screwdriver to set the two address
switches. Set the address switches per the control panel configuration.
The module's address switches provide a tens and ones value for the module's address. Set
the tens switch to 0 and the ones digit 1 for module 1 ; set the tens switch to 0 and the ones
digit 2 for module 2.
Notice!
The module reads the address switch setting only during power up. If you change the
switches after you apply power to the module, you must cycle the power to the module in
order for the new setting to be enabled.
Install the module
After you set the address switches for the proper address, install the module in the enclosure.
Mount the module into the enclosure's 3-hole mounting pattern using the supplied mounting
screws and mounting bracket.
Notice!
Remove all power (AC and battery) before making any connections. Failure to do so might
result in personal injury and/or equipment damage.
Wire to the control panel
2017.10 | 03 | F.01U.298.026
Add or Delete RF Wireless Devices, page 41
Installation Guide
Control Panel
Bosch Security Systems, Inc.