A-Link Plus Options; Domestic Dialing; Domestic Dialing Funtion - Bosch Solution 2000 Installation Manual

Control Panel
11.20

A-Link Plus Options

Item
A-Link Plus Options
Notice!
The A-Link options are available only for link through the telephone line. The options are not
related to connection through network or direct connection.
1 – Enable Upload/Download Using A-Link
Select this option to use the A-Link Plus software to initiate connection with the control panel
to program and control the control panel remotely. The control panel does not respond to A-
Link if this option is not selected.
Control panel establishes connection with A-Link Pus through callback method regardless of
this setting.
2 – Enable A-Link Call Back
If this option is selected and a callback telephone number is programmed, the remote
programming computer must be connected to the telephone line programmed in the callback
telephone number in Locations 159 to 174.
If this option is not selected, the installer can connect to a customer's control panel from any
remote location for Upload/Download operations without the control panel calling back to the
remote computer. The customer can initiate a modem call from the codepad by holding down
[6].
4 – Terminate A-Link Connection on Alarm
If an alarm occurs when the control panel is communicating with a remote computer using the
A-Link Plus software over the telephone line, the A-Link session is terminated and the relevant
alarm message is transmitted to the base station receiver.
If an alarm occurs that does not have to be reported to the base station receiver, the session
is not terminated.
11.21

Domestic Dialing

The locations of the primary and secondary telephone numbers for Receiver 1/2/3/4 are used
for base station and domestic dialing.
11.21.1

Domestic Dialing Funtion

When the control panel is activated into alarm, it dials the primary number. If a busy tone is
detected, or the call is not acknowledged, the control panel hangs up and dials the primary
number again. The control panel will try dialing the primary number up to 3 times. If all three
attempts are unsuccessful, the control panel tries dialing the secondary number. The control
panel will try the secondary number up to 3 times. If all dialing attempts are unsuccessful, the
control panel discontinues dialing. If another alarm is activated, the dialing sequence above
starts over again.
If a busy tone is not detected, the control panel assumes the telephone was answered and
sends its transmission. The transmission sequence consists of an identification beep, followed
by a siren tone and a pause. The transmission sequence is repeated until the control panel
receives an acknowledgment tone during the (3 sec about) pause . The control panel
Bosch Security Systems, Inc.
Location Option
0180 1 = Enable upload/download using A-Link
2 = Enable A-Link callback
4 = Terminate A-Link connection on alarm
8 = Reserved
Installation Guide
Communication Information | en
Default New
3
2017.10 | 03 | F.01U.298.026
79