Code To Isolate; Fault Analysis Mode - Bosch ICP-SOL2-P User Manual

Control Panel
2.
3.
5.5.2

Code to Isolate

This method restricts only those User Codes with the Code to Isolate priority level to isolate
zones.
If any User Code has this priority level, the method of standard isolating does not function.
How to Isolate a Zone
1.
2.
3.
5.6

Fault Analysis Mode

If a fault occurs, the FAULT or MAINS indicators flash and the codepad beeps once every min.
If the AC MAINS supply fails, the MAINS indicator flashes until the AC MAINS supply is
restored. Pressing the [#] button once acknowledges the fault and stops the codepad from
beeping once every min.
How to Determine the Type of System Fault
To determine which system fault occurred, enter Fault Analysis Mode by following the steps
below:
1.
2.
3.
Bosch Security Systems, Inc.
Enter the zone number (1 to 8), followed by the[*] button (for example, [1*] = Zone 1,
[2*] = Zone 2). Each zone to be isolated has a corresponding zone indicator that flashes.
If you selected an incorrect zone to be isolated, enter the incorrect zone number again
followed by the [*] button. Repeat Step 2 if more than one zone is to be isolated until all
zones to be isolated are selected.
Press the [#] button after all selected zones are isolated. Two beeps are heard and the
system returns to the disarmed state.
Press the [*] button followed by your User Code and the [*] button again to enter the
Isolating Mode (for example, [*2580*]). Three beeps sound and the STAY indicator
flashes.
Enter the zone number (1 to 8), followed by the [*] button (for example, [1*] = Zone 1,
[2*]= Zone 2). Each zone to be isolated has a corresponding zone indicator that flashes. If
you selected an incorrect zone to be isolated, enter the incorrect zone number again
followed by the[*] button. Repeat Step 2 if more than one zone is to be isolated until all
zones to be isolated are selected.
Press the [#] button after all selected zones are isolated. Two beeps sound and the
system returns to the disarmed state.
Hold down the [5] key until two beeps sound. The FAULT indicator remains steady and
the STAY and AWAY indicators flash in unison. A zone indicator displays the type of fault
that occurred (for example, Zone 1 = System Fault). Refer to Fault Indicators, page 20
for the list of possible system faults.
To further determine the type of fault condition, press and hold down the key that
corresponds to the zone indicator displayed. For example, if Zone 1 displayed System
Fault, press and hold the [1] key to display which system fault occurred.
To exit Fault Analysis Mode and return to the disarmed state, press the [#] key. The
FAULT indicator continues to display and the codepad stops sounding once a min.
Operation with ICON LCD Codepad | en
User's Guide
19
2014.05 | 01 | F01U298028