Rf Point Menu> [3] Remove Point Rfid; Rf Repeater Menu > [1] Add Repeater; Rf Repeater Menu > [2] Replace Repeater - Bosch B6512 Installation Manual

Control Panels
3.
4.
5.
6.
7.
20.2.3 [1] RF Point Menu> [3] Remove Point RFID
In this menu, you can remove RFID points.
Remove Point RFID
1.
2.
3.
4.
5.
20.2.4 [2] RF Repeater Menu > [1] Add Repeater
In this menu, you can add repeater points.
Add Repeater
1.
2.
3.
4.
5.
6.
7.
20.2.5 [2] RF Repeater Menu > [2] Replace Repeater
In this menu, you can replace Repeater points.
Replace Repeater
1.
2.
3.
4.
5.
Bosch Security Systems, Inc.
Use /Previous or /Next to scroll through the list of wireless points, and go to the
point for which you want to replace the device, or simply enter the point number.
Press Enter to replace the device. The keypad instructs you to reset the device.
Initiate activity for the desired RADION device (walk through the coverage pattern if
enrolling a motion detector, or press the button on the keyfob if enrolling a keyfob, or
open the door or window if enrolling a door/window contact), or press the RESET button
on an Inovonics device.
When the keypad indicates that the point was replaced, escape from the menu.
Verify the RFID shown on the keypad matches the RFID label on the activated device.
Enter the installer passcode, and then open the [1] Installer Menu.
Go to [2] Wireless > [1] RF Point Menu > [3] Remove Point RFID. The keypad lists any
enrolled points.
Use /Previous or /Next to scroll through the list of wireless points, and go to the
point for which you want to remove, or simply enter the point number.
Press Remove or Enter to remove the device. The keypad shows Point RFID removed.
Escape from the menu.
Ensure that the repeater is in a normal state.
Enter the installer passcode, and then open the [1] Installer Menu.
Go to [2] Wireless > [2] RF Repeater Menu > [1] Add Repeater. The keypad lists any
repeaters.
Use /Previous or /Next to scroll through the list, and go to the repeater number for
which you want to add a repeater, or enter the repeater number. Start with address 8
before adding additional repeaters.
Press Enter to add the repeater. The keypad instructs you to tamper the repeater.
Initiate discovery on a RADION repeater by opening the cover, or press the RESET button
on an Inovonics repeater.
When the keypad indicates that the repeater was added, escape from the menu.
Enter the installer passcode, and then open the [1] Installer Menu.
Go to [2] Wireless > [2] RF Repeater Menu > [2] Replace Repeater. The keypad lists any
existing repeaters.
Use /Previous or /Next to scroll through the list of repeaters, and go to the repeater
you want to replace, or simply enter the repeater number.
Press Enter to replace the device. The keypad instructs you to reset the new device.
Initiate discovery on a RADION device per the device instructions, or press the RESET
button on an Inovonics device.
Installation Manual
Keypad Installer menu | en 121
2018.07 | 16 | F.01U.287.180