7. Select Internal Storage as file destination, then click Transfer. The bitmap
file is successfully transferred to the terminal.
The new screen saver takes affect the next time the screen saver is activated.
Your bitmap file should be small in size. A large bitmap will
TIP
impact performance of terminal operations.
Configure Key Repeat Settings
You can configure key repeat settings for the terminal keys or attached keyboard
of the connected terminal.
You cannot change the key repeat settings from the on-terminal
TIP
configuration screens. If you want to change this setting, you must
connect to the terminal through a web browser.
(1)
The web browser feature is not supported on PanelView 800 terminals from firmware revision 3.011 onwards.
The repeat rate is the speed at which a character repeats per second when you
hold down a key. The repeat delay is the amount of time, in milliseconds, that
elapses before a character begins to repeat when you hold down a key.
Follow these steps to change the repeat settings for keys using PanelView
(1)
Explorer.
1. Go to the PanelView Explorer Startup window.
2. Click the Terminal Settings link.
3. Click the Display/Input tab.
(1)
The PanelView Explorer feature is not supported on PanelView 800 terminals from firmware revision 3.011
onwards.
Rockwell Automation Publication 2711R-UM001E-EN-E - January 2017
Configuration Mode
Chapter 2
(1)
31