Allen-Bradley PanelView 800 2711R-T4T User Manual page 109

PanelView 800 Terminal Alerts
Category ID
Alert 2090 Invalid Control password.
Alert 2091 VNC Server is Disabled.
Alert 2092 Ethernet port is disabled.
Alert 2093 Serial port is disabled.
Alert 2094 Existing VNC client connection will be terminated.
Alert 2095 Cannot edit recipe for running application.
Alert 2096 Recipe with the same name already exists
Alert 2097 Recipe Name cannot contain more than 31
Alert 2098 The Name cannot be blank and must contain only
Alert 2099 Deletion of a recipe in a design secured
Alert 2100 Renaming of a recipe in a design secured
Alert 3001 Available memory is too low to run the
Multilanguage 8193 Language switch ignored. Application was not
Description
Confirm (Y/N)?
characters. Please choose another name.
alphanumeric characters plus [ $'@!()_- ].
application is not allowed. Refer to user manual.
application is not allowed. Refer to user manual.
application.
configured with new language. An attempt was
made to switch to a language that is not
configured for this application.
Rockwell Automation Publication 2711R-UM001E-EN-E - January 2017
Troubleshoot the System
Corrective Action
Password must contain at least one special
character.
Enable VNC Server to change/reset password.
Go to Port Settings on the terminal to enable the
Ethernet port.
Go to Port Settings on the terminal to enable the
Serial port.
Press Yes to terminate the VNC connection, or No to
cancel.
Unload the application and try again.
Make sure the recipe name is unique.
Make sure the recipe name does not exceed 31
characters.
Make sure the name contains only alphanumeric
characters plus [ $'@!()_- ].
Make sure the application is not design secured.
Make sure the application is not design secured.
Please try to release some memory or this may lead
to fatal error.
Either add the specified language and associated
strings or remove the unconfigured language
selection.
Chapter 8
109