Allen-Bradley PanelView 800 2711R-T4T User Manual page 111

Firmware Installation and Loading
Message
Load Firmware Image into RAM
Write Firmware Image into Flash
Complete and Successful Firmware Installation
Firmware Image Validation (CRC/Format) Failure
Firmware Image Compatibility Failure
Firmware Write to Flash error
Firmware Read-After-Write Verify
Invalid or missing Firmware Image
Other Commonly Observed Status Codes
Message
Boot Loader connects to PC via USB Device
Boot Loader loads Firmware Image into RAM
Boot Loader jumps to Operating System
Operating System start up
Operating System Initialize
Application Registration and Initialize
Application Load and Execute
POST errors are fatal and most likely due to failed hardware. A fatal error during
firmware installation and loading is most likely recoverable by installing the
appropriate firmware.
Interpret the LED Indicators at Startup
The PanelView 800 terminals have indicators to isolate operating problems. They
can be seen through the battery cover on the back of the unit.
• Comm indicator for communication
• Fault indicator for hardware faults
Rockwell Automation Publication 2711R-UM001E-EN-E - January 2017
Troubleshoot the System Chapter 8
State Code
Update 1E
Update A5
Update OK
Fatal 1E
Fatal 1F
Fatal A5
Fatal D2
Fatal 0A
State Code
AutoTest 0A
AutoTest E6
AutoTest FF
Boot G0
Init I1...J0
Init N1...N3
Load N4...N6
111