Raymarine autopilot control unit Owner's Handbook Manual page 21

8
You can adjust the default response level in either User or Dealer
Calibration (see page 89). This determines the default power-up
response level.
However, when using your autopilot on a day-to-day basis, you can
make temporary adjustments to the response level. By doing this
you can match autopilot performance to different conditions.
Temporary changes to response – Type 150G/400G
With these points in mind, you should use the following procedure to
make temporary adjustments to the response level when required:
1. Display the RESPONSE screen by pressing either the resp key or
Note: The RESPONSE screen is set as a default data page (see
page 81) so you can also access it by pressing disp and then scrolling
through the data pages.
2. Press -1 or +1 or the up arrow or down arrow keys to change the
3. Press disp or wait for 5 seconds to return to the previous display.
Note: You will lose these temporary changes to response level
whenever the system is powered off. You can make permanent
adjustments in User or Dealer Calibration (see page 89).
ST7001+ Autopilot Control Unit - Owner's Handbook
the -1 and +1 keys together momentarily.
OR
and
response level.
Decrease Increase
response OR OR
response
D5453-1