Mortise Lock Function Changing Instructions - Assa Abloy Sargent 8200 Installation Instructions Manual

BHL Trim
8200 Mortise Lock
Installation Instructions
2

Mortise Lock Function Changing Instructions

How to change function of lock:
Green catch screw must be located in following
three (3) locations as designated on lock case to
create desired function:
1. 05, 37 & 38 functions
2. 04, 06, 13 & 31 functions
3. 36 function
NOTE:
WHEN MOVING GREEN CATCH SCREW TO 04, 06,
13 & 31 FUNCTIONS, HUB POSITION MUST BE AT
45° AS SHOWN ON LOCKCASE (FIGURE 1) .
Items needed to create each of the following functions:
Function
04 (F07)
05 (F04)
06
13 (F31)
31
36
37 (F05)
38 (F32)
#41 Cylinder is standard for both single & double cylinder functions for 1-3/4" thick door
NOTE:Trim-one-side functions always require an inside trim assembly which can be used on the
inside or outside of the door (to order Trim one-side kit (for all trim except PT or FE) order part # 82-4611.
*** 130 KB thumb turn is used with rose trim only. Escutcheon trims requiring thumb turns
must be preassembled at factory.
1-800-727-5477 • www.sargentlock.com
Copyright © 2017, Sargent Manufacturing Company, an ASSA ABLOY Group
company. All rights reserved. Reproduction in whole or in part without the express
written permission of Sargent Manufacturing Company is prohibited.
Outside Inside Trim One
Lever Lever Side Kit
X X
X X
X X
X X
X X
X X
X X
X X
3
Green Catch Screw
Outside Inside Thumb
Cylinder Cylinder Turn
X
X X***
X
X
X
X
X X
Figure 1
A8131E 11/17