DPS Telecom NetGuardian 240T Hardware User Manual page 56

52
§
Enter User Name and Password Information
o Enter a User name and press enter. If it's a valid user, it will now ask for a password. The default
username is Administrator.
o Enter the password. If the login was accepted, it should say "User logged in". The default password is
printed on the Default Network Settings tag.
§
Switch to Binary Mode
o Type in "bin" to switch to binary mode. Press enter.
§
Input Firmware Filename
o Type in "put XXXXX.tsk" with the firmware filename in place of the X's.
§
Reboot the Unit to Accept New Firmware
o If the new firmware sent 'OK', type in "literal REBT" and press enter. This is case sensitive. "literal"
should be in lowercase and "REBT" should be all uppercase. This will reboot the unit to accept the new
firmware.
§
Type "bye" to end the FTP session and reboot the unit with the new firmware.
The figure below shows a sample session using command line in Windows.