YOKOGAWA TA720 User Manual page 96

*RST
Function Initializes the setup data.
Syntax *RST
Example *RST
Description Executes the same operation as when the
[Execute] soft key of the INIT
(SHIFT+MARKER) key is pressed. For details
on initialization, see the TA720 User's Manual .
*SRE
Function Sets the service request enable register or
queries the current setting.
Syntax *SRE {<NRf>}
*SRE?
<NRf>=0 to 255
Example *SRE 239
*SRE?
-> 239
*STB?
Function Queries the status byte register.
Syntax *STB?
Example *STB?
-> 4
Description For details on the status byte register, see
chapter 5, "Status Report."
*TRG?
Function Executes the same operation as when the
SINGLE key is pressed.
Syntax *TRG?
Description The multi-line message GET (Group Execute
Trigger) also performs the same operation as
this command.
*TST?
Function Performs a self-test and queries the result.
Syntax *TST?
Example *TST?
-> 0
Description • Executes the same operation as the [Board]
test of the [Selftest] soft key.
• If the all the tests terminate normally, "0" is
returned. Otherwise, a non-zero value is
returned.
*WAI
Function Holds the subsequent command until the
completion of the specified overlap operation.
Because the TA720 does not support overlap
commands, the command is discarded.
Syntax *WAI
IM 704510-17E
4.23 Common Command Group
4
4-73