Table of Contents
Advertisement
Explanation
IM 704510-17E
Note
•
For details on the keyboard operation, see section 4.4, "Entering Values and Character
Strings" in the TA720 User's Manual IM704510-01E .
•
User name and password are case-sensitive.
• Setting the TCP/IP
To use the network interface function, the following TCP/IP settings must be entered.
• IP address
• Subnet mask
• Default gateway
For details on how to enter these parameters, see section 12.2, "Setting the TCP/IP"
in the TA720 User's Manual IM704510-01E .
Enter the following settings when using a controller to set information that can be
specified through key operation on the TA720 or when outputting setting parameters or
output waveform data to the controller.
• Setting the User Name and Password
The network interface has a user verification function. A user name and password for
the TA720 are set in advance.
• Setting the User Name
Enter the password using up to 15 characters. The default setting is "anonymous."
• Setting the password
Enter the password using up to 15 characters.
• Setting the Timeout Time
The connection to the TA720 is automatically dropped if there is no access to the
TA720 for the specified time. The default setting is Infinite (no timeout).
• Setting the TCP/IP
For details, see section 12.2, "Setting the TCP/IP" in the TA720 User's Manual
IM704510-01E .
Note
•
If the user verification fails, connection to the TA720 is dropped.
•
Password is not required if the user name is "anonymous."
•
If you change the user name, password, timeout time, or TCP/IP settings, power-cycle the
TA720 to activate the new settings.
2.4 Setting the TA720
2-5
2
Advertisement
Table of Contents
