Fastening The Cabinet To The Floor And Roof/Wall (Marine Units) - ABB ACS880-07 Hardware Manual

72 Mechanical installation
Fastening the cabinet to the floor and roof/wall (marine
units)
Obey the general cabinet installation rules also in the installation of the marine variant.
See section General rules
See the dimension drawing delivered with the drive for details of the fastening points. Top
fastening brackets are included in the delivery.
Fasten the cabinet to the floor and roof (wall) as follows:
1. Bolt the unit to the floor through the flat bars at the base of the cabinet using M10 or
M12 screws.
2. If there is not enough room behind the cabinet for installation, clamp (a) the rear edges
of the flat bars (c) to the floor. See the figure below.
3. Remove the lifting lugs and bolt the corner brackets (d) to the lifting lug holes. Fasten
the corner brackets to the rear wall and/or roof with suitable hardware such as
U-brackets (e).
2
b
a
c
on page 70.
3
d
e
M16
2. Clamping the cabinet to the
floor at the back
a Clamp (not included)
b Back panel of cabinet
c Flat bars at base of cabinet
3. Fastening the cabinet at the
top
d Corner bracket (included)
e U-bracket (not included)