Rcm Marking; Weee Marking; Eac (Eurasian Conformity) Marking; Disclaimers - ABB ACS880-07 Hardware Manual

228 Technical data

RCM marking

RCM marking is required in Australia and New Zealand. An RCM mark is attached to the
drive modules to verify compliance with the relevant standard (IEC 61800-3:2004),
mandated by the Trans-Tasman Electromagnetic Compatibility Scheme.
For fulfilling the requirements of the standard, see section
3:2004.

WEEE marking

The drive is marked with the wheelie bin symbol. It indicates that at the end of life the drive
should enter the recycling system at an appropriate collection point and not placed in the
normal waste stream. See section Disposal on page 221.

EAC (Eurasian Conformity) marking

The drive has EAC certification. EAC marking is required in Russia, Belarus and
Kazakhstan.

Disclaimers

Generic disclaimer


The manufacturer shall have no obligation with respect to any product which (i) has been
improperly repaired or altered; (ii) has been subjected to misuse, negligence or accident;
(iii) has been used in a manner contrary to the Manufacturer's instructions; or (iv) has
failed as a result of ordinary wear and tear.

Cybersecurity disclaimer


This product is designed to be connected to and to communicate information and data via
a network interface. It is Customer's sole responsibility to provide and continuously ensure
a secure connection between the product and Customer network or any other network (as
the case may be). Customer shall establish and maintain any appropriate measures (such
as but not limited to the installation of firewalls, application of authentication measures,
encryption of data, installation of anti-virus programs, etc) to protect the product, the
network, its system and the interface against any kind of security breaches, unauthorized
access, interference, intrusion, leakage and/or theft of data or information. ABB and its
affiliates are not liable for damages and/or losses related to such security breaches, any
unauthorized access, interference, intrusion, leakage and/or theft of data or information.
Compliance with the EN 61800-