Arc welding
Fastening the cabinet by arc welding is not recommended. However, if the arc welding is
the only mounting option, proceed as follows: Connect the return conductor of the welding
equipment to the cabinet frame at the bottom within 0.5 meters (1.5 ft) of the welding point.
Note: The thickness of the zinc coating of the cabinet frame is 20 micrometers (0.79 mil).
WARNING! Make sure that the return wire is connected correctly. Welding current
must not return via any component or cabling of the drive. If the welding return
wire is connected improperly, the welding circuit can damage electronic circuits in
the cabinet.
WARNING! Do not inhale the welding fumes.
Mechanical installation 75