Fastening The Cabinet To The Floor And Roof/Wall (Marine Units, +C121) - ABB ACS880-37 Hardware Manual

Fastening the cabinet to the floor and roof/wall (marine
units, +C121)
Follow the general rules given in section
See the dimension drawing delivered with the drive for the locations of the fastening holes
in the flat bars below the cabinet and for fastening points at the top of the cabinet.
Fasten the cabinet to the floor and roof (wall) as follows:
1. Bolt the unit to the floor through the flat bars at the base of the cabinet using M10 or
M12 screws.
2. If there is not enough room behind the cabinet for installation, clamp (a) the rear edges
of the flat bars (c) to the floor.
3. Remove the lifting lugs and bolt the corner brackets (d) to the lifting lug holes. Fasten
the corner brackets to the rear wall and/or roof with suitable hardware such as
U-brackets (e).
2
b
a
c
General rules on page 67.
3
d
e
M16
Mechanical installation 69
2. Clamping the cabinet to the
floor at the back
a Clamp (not included)
b Back panel of cabinet
c Flat bars at base of cabinet
3. Fastening the cabinet at the
top
d Corner bracket (included)
e U-bracket (not included)