Sokkia im-101 Operator's Manual page 142

8. Check the EP.
Check the coordinate for the EP, and press [OK].
9. Quit inputting the IPs.
Press [OK] in the screen shown in step 8.
The screen returns to <Curve Element Setting>.
25.8.2 Inputting Curve Elements
• Automatic setting of the BP (step 3): You can set the BP for the next curve as the IP or the EP for the previous
curve (KA-2 or the EC point) in advance.
• If multiple curves overlap when the next curve is calculated based on the input curve elements (when [OK]
is pressed), the screen below is displayed.
• If the element starting point is located before the BP, the distance between those two points is displayed with
minus (-).
• If the element ending point exceeds the EP, the distance between those two points is displayed with plus (+).
Pressing [YES] continues the calculation, ignoring the overlap of the curves.
Pressing [NO] stops the calculation and return to the Input Element screen.
1. Input the IPs.
25.8.1 Inputting IPs (Intersection Points)
2. Enter the Input Element screen.
Select "Input element".
Element 2 - El em ent 3
1 m m
C u r v e o v e r l a p
C o n t i n u e ?
YES
BP- E l e m e n t 1
- 1 0 m m
C u r v e o v e r l a p
C o n t i n u e ?
YES
Element n - E D
1 0 m m
C u r v e o v e r l a p
C o n t i n u e ?
YES
136
25. ROUTE SURVEYING
E P
2 0 0 . 0 0 0
N p :
E p : 4 0 0 . 0 0 0
<C urv e number:2>
NO
NO
NO
Define elements
Input I P
Input el em ent
Revi ew el em ent
Cl ear
OK