Deleting A Job - Sokkia im-101 Operator's Manual

4. Align the cursor with the desired JOB as the current JOB
and press {ENT}.
The JOB is determined.
5. Press {ENT}.
<JOB selection> is restored.
6. Align the cursor with "Coord search JOB" and press [LIST].
<Coord search JOB> is displayed.
7. Align the cursor with the desired JOB as the coordinate
search JOB and press {ENT}.
The JOB is determined and <JOB> is restored.

• The list of JOB names is contained on up to 2 pages.
PROCEDURE Inputting a JOB name
1. Select "JOB" in Data mode.
2. Select in advance the JOB whose name to be changed.
"PROCEDURE JOB selection and scale factor setting"
3. Select "JOB details" in <JOB>. After inputting the detailed
information for the JOB, press [OK].
<JOB> is restored.
• Enter the scale factor for the current JOB.

• Maximum length of JOB name: 12 (alphanumeric)
• Scale factor input range : 0.50000000 to 2.00000000
(*1.00000000)
"*" : Factory setting

29.2 Deleting a JOB

It is possible to clear the data within a designated JOB. After the data has been cleared, the JOB name returns
to the name allocated when the iM was shipped.

• A JOB that has not been output to an auxiliary device (displayed with *) cannot be deleted.
PROCEDURE
1. Select "JOB" in Data Mode.
JOB
JOB selection
JOB details
JOB deletion
Comms output
Comms setup
J OB detai l s
J OB name
S C A LE : 1. 00000000
163
29. SELECTING/DELETING A JOB
OK