Sokkia im-101 Operator's Manual page 67

1. Press [S-O] on the third page of the OBS mode screen to
display <S-O>.
2. Select "Occ.orien." to set the instrument station data and
azimuth angle of the backsight point.
"13.1 Entering Instrument Station Data and Azimuth
Angle PROCEDURE Reading in Registered Coordinate
Data"
3. Select "S-O data". <S-O Coord> is displayed.
4. Enter the coordinates of the setting-out point.
• When [LOAD] is pressed, registered coordinates can be
recalled and used as setting-out coordinates.
"13.1 Entering Instrument Station Data and Azimuth
Angle PROCEDURE Reading in Registered
Coordinate Data"
• Pressing [DISP] switches between the distance input
modes.
5. Press [OK] to set the setting-out data.
• The tilt screen is displayed if the instrument is out of level.
Level the instrument.
"7.2 Levelling"
6. The difference in the distance and angle calculated with the
set instrument station and the target point is displayed.
Rotate the top of the instrument until "dHA" is 0° and place
the target on the sight line.
7. Press [MEAS] to begin setting-out measurement.
The target and the distance of the point to be set out is
displayed (S-OΔ HD).
15. SETTING-OUT MEASUREMENT
S-O
Occ.Orien
S-O data
Observation
EDM
S-O Coord
HR
LOAD
S-O HD
H
H
LOAD
S-O HD
dHA
HD
ZA
HA-R
REC
S-O HD
dHA
HD
ZA
HA-R
61
OK
DISP
40.0000
DISP OK
C
MEAS
DISP
C