Sokkia im-101 Operator's Manual page 149

2. Sight the width peg and press [MEAS] to start
measurement. The coordinates and measurement distance
of the width peg, vertical angle and horizontal angle are
displayed.
Press [STOP] to stop the measurement.
3. The coordinates and point name shown in this screen are
used to display the results for the center peg.
4. Press [YES] in the screen shown in step 3 to display the
route width and point name of the width peg.
5. The next width peg can then be set by pressing [OK].

• The rules regarding the assigning of point names to width pegs and center pegs are the same as those for
when calculating width pegs in automatic calculation of cardinal points.
"25.8.5 Automatic calculation of cardinal points  Rules regarding the assigning of point names to
automatically calculated pegs"
• The rules regarding the assigning of point names to center pegs are the same as those for when calculating
arbitrary points.
"25.8.6 Arbitrary point calculation  Rules regarding the automatic assigning of point names to arbitrary
points"
25.8.8 Setting parameters
When configuring curve properties in 25.8.2 Inputting Curve Elements, it is possible to preset which curve
(clothoid or parabola) to calculate and which point to use as the BP Point of the next curve: the IP Point of the
previous curve or the end-point (KA-2 or EC Point) of the previous curve.
PROCEDURE
1. In the second page of the OBS mode screen, press
[MENU], then select "Road".
2. Select "Alignment" to enter the Route Calculation menu.
A l i g n m e n t / R o a d t o p o
N p :
E p :
LOAD
N
E
SD
ZA
HA-R
A l i g n m e n t / R o a d t o p o
N p :
E p :
C o n f i r m ?
Road topo/CL peg
N
E
St a.. i ng
N o. 2
143
25. ROUTE SURVEYING
0 . 0 0 0

0 . 0 0 0
MEAS OK
1 6 8 . 3 2 9
1 9 9 . 3 6 1

3 . 7 8 0 m
7 8 4 3 ' 2 6 "
2 1 4 7 ' 1 6 "
STOP
1 6 8 . 3 2 9
1 9 9 . 3 6 1
NO YES
173. 318
196. 031
123. 456m
REC S-O OK